:	Jun 17, 2004

.

Disconnect the battery ground cable.

.

Remove the fuel rail.

.

Position the injector harness aside.   Release the 2 clips.   Disconnect the 3 fuel injector electrical connectors.

.

: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination. Remove the valve cover.   Release the wiring harness retaining clip.   Remove the 2 bolts.   Remove the 4 studs.

.

:   Do not disassemble further if the component is removed for access only. Remove and discard the gasket.

.

:   Note the fitted position. Remove the bolts and studs. Remove and discard the seals.

.

Install the bolts and studs.   Install the new O-ring seals.   Install the new gasket.

.

Install the valve cover.   Clean the component mating faces.   Evenly and progressively tighten the bolts and studs, in the sequence shown, to 10 Nm (7 lb.ft).   Secure the electrical harness with the clip.

.

Install the injector harness.   Secure with the clips.   Connect the fuel injector electrical connectors.

.

Install the fuel rail.

.

Connect the battery ground cable.